Convertibars Kawasaki: ZZR1200 Bedienungsanleitung PDF herunterladen

Kawasaki ZZR1200

Bike Specific Install Notes and Tips

This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to

set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike

Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with

out pulling taught or kinking any lines, and without damaging any part of the motorcycle

Important Installation Considerations

Intake duct covers need to be trimmed. Range of travel limited by fairing,

intakes, and guages. Customize your riding position, but once set, little change

is allowed because of restrictions.

Special Kit Requirements/Installation Tips

1. Contact - Slight fairing contact is ok as long as the steering stops can be

reached with out damaging the fairing

2. Trimming - Depending on handlebar position, the fairing side pieces(lower

fairing that is nearest the forks) may need to be trimmed for riser pipe

clearance. Clamping a piece of wood(a straight edge) and using a dremel is

recommended.

Handlebar Positioning

1. When the bars are in the up position, with the wheel straight, the clamps should

be rotated so the handlebar risers are at approximately the 7 and 5 - O'Clock

positions(as the rider is looking down at the top of the fork tubes) This will allow

clearance with the upper fairing and windshield as you turn stop to stop.

Restrictions

1. Upper fairing and or windshield can be trimmed for more rise.

2. Foreword Positions restricted by instrument panel

3. Kit works well as a riser, but there are restrictions when converting to a lower

handlebar position.

4. Fairing side pieces or intake ducts interfere with the riser when rotating the

Cyclops Clamps. The Cyclops Clamps need to be rotationally positioned so

riser is either in front of or behind the forks. Trimming the fairing side pieces

could also eliminate this restriction.

Line Routing

1. Electrical Lines to be freed from their brackets and or Zip Ties, and run on the

rider's side of the forks

Recommended Riser Trim Length

1. 6.5" Riser Length = Trim Number 11

Recommended parts and replacement lines

1 2

Kawasaki ZZR1200 1

Inhaltsverzeichnis

Seite 1 - Kawasaki ZZR1200

Kawasaki ZZR1200 Bike Specific Install Notes and TipsThis is an aftermarket product that fits up different than the stock components, therefore, the

Seite 2

1. Hydraulic Brake Line Top Fitting - 000(Straight) 2. Hydraulic Brake Line = Stock + 4"

Kommentare zu diesen Handbüchern

Keine Kommentare

Convertibars Kawasaki: ZZR1200 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für Motorräder Convertibars Kawasaki: ZZR1200 herunter. ConvertiBARS Kawasaki: ZZR1200 User Manual [en] [pl] [cs] [de] Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für Motorräder Convertibars Kawasaki: ZZR1200