Convertibars Suzuki: TL1000S Bedienungsanleitung PDF herunterladen

Suzuki TL1000S

Bike Specific Install Notes and Tips

This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to

set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike

Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with

out pulling taught or kinking any lines, and without damaging any part of the motorcycle

Important Installation Considerations

Fairing stay restricts rise to about 1 inch. For more than an inch of rise, the

fairing stay must be modified or removed.

Special Kit Requirements/Installation Tips

1. Contact - Slight fairing contact is ok as long as the steering stops can be

reached with out damaging the fairing

2. Zip ties or brackets holding excess electrical lines will need to be cut or removed

to free up extra length.

3. Trimming - Depending on handlebar position, the upper fairing and or

windshield may need to be trimmed for clearance. Marking the line with tape

and using a dremel tool for trimming is recommended.

Restrictions

1. Fairing stay/windshield Frame - restricts rise. If the fiaring stay is modified or

removed, more rise can be achieved.

Recommended Riser Trim Length

1. 6.5" Riser Length = Trim Number 11

Recommended parts and replacement lines

1. Hydraulic Brake Line Top Fitting - 90 degree face to the side

2. Hydraulic Brake Line = Stock + 3"

3. Throttle Lines - Ok rerouted

4. Cable Clutch Line - Ok rerouted

1 2

Suzuki TL1000S Bike Specific Install Notes and TipsThis is an aftermarket product that fits up different than the stock components, therefore, the in

Seite 2

Keine Kommentare

Convertibars Suzuki: TL1000S Bedienungsanleitung